This is a 100K Ohm (100 kΩ) single-turn cermet trimmer potentiometer with a linear taper, rated 0.5 W. A 100K Ohm value is commonly used for high-impedance inputs, RC timing, op-amp feedback and voltage dividers that should draw very little current. The 3/8" square body adjusts from the top and mounts through-hole by its pins.
Key Features
- 100K Ohm (100 kΩ) resistance, ±10% tolerance
- Single-turn, top-adjust trimmer
- Linear taper; cermet element rated 0.5 W
- 3/8" square body with through-hole pin terminals
Specifications
| Resistance | 100,000 Ohms |
|---|---|
| Tolerance | ±10% |
| Power rating | 0.5 W |
| Number of turns | 1 |
| Taper | Linear |
| Resistive material | Cermet |
| Type | 3/8" square |
| Actuator orientation | Top |
| Mounting | Through hole |
| Termination | Pins |
| SKU | 18CPH100K |
What's Included
- 100K Ohm cermet trimmer potentiometer
Ideal For
Set-and-forget 100K Ohm calibration and trimming on circuit boards and prototypes.
Frequently Asked Questions
What is a trimmer potentiometer?
A small pot meant to be set once (or rarely) with a screwdriver or fingertip, usually during calibration, rather than a front-panel control turned every day.
Linear or audio taper?
Linear. The 100K Ohm resistance changes evenly as you turn it, which is what you want for calibration, dividers and setpoints.
What is the resistance code for 100K Ohm?
In the three-digit code used on many potentiometers and trimmers, 100K Ohm is written 104: the first two digits (10) followed by 4 zeros. Markings vary by maker, so go by the listed value.


