This is a 500K Ohm (500 kΩ) single-turn cermet trimmer potentiometer with a linear taper, rated 0.5 W. A 500K Ohm value is commonly used for long RC time constants, high-impedance bias networks and dividers that must draw very little current. The 3/8" square body adjusts from the top and mounts through-hole by its pins.
Key Features
- 500K Ohm (500 kΩ) resistance, ±10% tolerance
- Single-turn, top-adjust trimmer
- Linear taper; cermet element rated 0.5 W
- 3/8" square body with through-hole pin terminals
Specifications
| Resistance | 500,000 Ohms |
|---|---|
| Tolerance | ±10% |
| Power rating | 0.5 W |
| Number of turns | 1 |
| Taper | Linear |
| Resistive material | Cermet |
| Type | 3/8" square |
| Actuator orientation | Top |
| Mounting | Through hole |
| Termination | Pins |
| SKU | 18CPH500K |
What's Included
- 500K Ohm cermet trimmer potentiometer
Ideal For
Set-and-forget 500K Ohm calibration and trimming on circuit boards and prototypes.
Frequently Asked Questions
What is a trimmer potentiometer?
A small pot meant to be set once (or rarely) with a screwdriver or fingertip, usually during calibration, rather than a front-panel control turned every day.
Linear or audio taper?
Linear. The 500K Ohm resistance changes evenly as you turn it, which is what you want for calibration, dividers and setpoints.
What is the resistance code for 500K Ohm?
In the three-digit code used on many potentiometers and trimmers, 500K Ohm is written 504: the first two digits (50) followed by 4 zeros. Markings vary by maker, so go by the listed value.


