500 Ohm (500 Ω) Cermet Trimmer Potentiometer – Single Turn, Linear, 0.5W, 3/8" Square, Top Adjust, Through Hole
500 Ohm (500 Ω) Cermet Trimmer Potentiometer – Single Turn, Linear, 0.5W, 3/8" Square, Top Adjust, Through Hole
500 Ohm (500 Ω) Cermet Trimmer Potentiometer – Single Turn, Linear, 0.5W, 3/8" Square, Top Adjust, Through Hole
  • Load image into Gallery viewer, 500 Ohm (500 Ω) Cermet Trimmer Potentiometer – Single Turn, Linear, 0.5W, 3/8" Square, Top Adjust, Through Hole
  • Load image into Gallery viewer, 500 Ohm (500 Ω) Cermet Trimmer Potentiometer – Single Turn, Linear, 0.5W, 3/8" Square, Top Adjust, Through Hole
  • Load image into Gallery viewer, 500 Ohm (500 Ω) Cermet Trimmer Potentiometer – Single Turn, Linear, 0.5W, 3/8" Square, Top Adjust, Through Hole

500 Ohm (500 Ω) Cermet Trimmer Potentiometer – Single Turn, Linear, 0.5W, 3/8" Square, Top Adjust, Through Hole

18CPH500
Regular price
$0.65
Sale price
$0.65
Regular price
Sold out
Unit price
per 
Shipping calculated at checkout.

This is a 500 Ohm (500 Ω) single-turn cermet trimmer potentiometer with a linear taper, rated 0.5 W. A 500 Ohm value is commonly used for low-impedance adjustments such as current trimming, bias tweaks or a fine-adjust leg in series with a fixed resistor. The 3/8" square body adjusts from the top and mounts through-hole by its pins.

Key Features

  • 500 Ohm (500 Ω) resistance, ±10% tolerance
  • Single-turn, top-adjust trimmer
  • Linear taper; cermet element rated 0.5 W
  • 3/8" square body with through-hole pin terminals

Specifications

Resistance 500 Ohms
Tolerance ±10%
Power rating 0.5 W
Number of turns 1
Taper Linear
Resistive material Cermet
Type 3/8" square
Actuator orientation Top
Mounting Through hole
Termination Pins
SKU 18CPH500

What's Included

  • 500 Ohm cermet trimmer potentiometer

Ideal For

Set-and-forget 500 Ohm calibration and trimming on circuit boards and prototypes.

Frequently Asked Questions

What is a trimmer potentiometer?
A small pot meant to be set once (or rarely) with a screwdriver or fingertip, usually during calibration, rather than a front-panel control turned every day.

Linear or audio taper?
Linear. The 500 Ohm resistance changes evenly as you turn it, which is what you want for calibration, dividers and setpoints.

What is the resistance code for 500 Ohm?
In the three-digit code used on many potentiometers and trimmers, 500 Ohm is written 501: the first two digits (50) followed by 1 zero. Markings vary by maker, so go by the listed value.