This is a 20K Ohm (20 kΩ) single-turn cermet trimmer potentiometer with a linear taper, rated 0.5 W. A 20K Ohm value is commonly used for op-amp gain and offset trimming, sensor calibration and voltage dividers with low current draw. The 3/8" square body adjusts from the top and mounts through-hole by its pins.
Key Features
- 20K Ohm (20 kΩ) resistance, ±10% tolerance
- Single-turn, top-adjust trimmer
- Linear taper; cermet element rated 0.5 W
- 3/8" square body with through-hole pin terminals
Specifications
| Resistance | 20,000 Ohms |
|---|---|
| Tolerance | ±10% |
| Power rating | 0.5 W |
| Number of turns | 1 |
| Taper | Linear |
| Resistive material | Cermet |
| Type | 3/8" square |
| Actuator orientation | Top |
| Mounting | Through hole |
| Termination | Pins |
| SKU | 18CPH20K |
What's Included
- 20K Ohm cermet trimmer potentiometer
Ideal For
Set-and-forget 20K Ohm calibration and trimming on circuit boards and prototypes.
Frequently Asked Questions
What is a trimmer potentiometer?
A small pot meant to be set once (or rarely) with a screwdriver or fingertip, usually during calibration, rather than a front-panel control turned every day.
Linear or audio taper?
Linear. The 20K Ohm resistance changes evenly as you turn it, which is what you want for calibration, dividers and setpoints.
What is the resistance code for 20K Ohm?
In the three-digit code used on many potentiometers and trimmers, 20K Ohm is written 203: the first two digits (20) followed by 3 zeros. Markings vary by maker, so go by the listed value.


