10 Pack 100K Ohm (100 kΩ) Multi-Turn Cermet Potentiometers with Knob – 15 Turns, Linear, 0.75W, 3/4" Rectangular, Side Adjust, Through Hole

10 Pack 100K Ohm (100 kΩ) Multi-Turn Cermet Potentiometers with Knob – 15 Turns, Linear, 0.75W, 3/4" Rectangular, Side Adjust, Through Hole

18MTK100KPK10
Regular price
$19.99
Sale price
$19.99
Regular price
Sold out
Unit price
per 
Shipping calculated at checkout.

This pack contains 10 × 100K Ohm (100 kΩ) multi-turn cermet potentiometers with a linear taper, rated 0.75 W, each with an adjuster knob. They take 15 turns end to end, so you can set a value much more finely than with a single-turn pot. A 100K Ohm value is commonly used for high-impedance inputs, RC timing, op-amp feedback and voltage dividers that should draw very little current.

Key Features

  • 100K Ohm (100 kΩ) resistance, ±10% tolerance
  • 15-turn adjustment for fine, precise settings
  • Knob for side adjustment by hand
  • Linear taper; cermet element rated 0.75 W
  • 3/4" rectangular body with through-hole pins
  • 10 pieces per pack

Specifications

Resistance 100KΩ (100,000 Ohms)
Tolerance ±10%
Power rating 0.75 W
Number of turns 15
Taper Linear
Resistive material Cermet
Type 3/4" rectangular, with knob
Actuator orientation Side
Mounting Through hole
Termination Pins
Pack quantity 10
SKU 18MTK100KPK10

What's Included

  • 10 × 100K Ohm multi-turn potentiometers with knob

Ideal For

Precise 100K Ohm calibration of sensors, references and gain stages on prototypes and test fixtures.

Frequently Asked Questions

Why choose a multi-turn pot?
Spreading the full resistance range over 15 turns makes each turn change the value only slightly, so it's much easier to hit an exact setting and it is less likely to drift if bumped.

Linear or audio taper?
Linear. The 100K Ohm resistance changes evenly as you turn it, which is what you want for calibration, dividers and setpoints.

What is the resistance code for 100K Ohm?
In the three-digit code used on many potentiometers and trimmers, 100K Ohm is written 104: the first two digits (10) followed by 4 zeros. Markings vary by maker, so go by the listed value.